While it is true that some of the hydraulic lift parts are different between the 1450 and a 1X9 series tractors, I don't think it would take much to make one work on the other.
I believe that the only real difference is the location of the control valve, with the valve being located on the steering column on the 1450, and on the side of the dash tower on the 1X9's this changes the plumbing and the location of the "valve handle lever". With the differences being so small and so few, it is my belief that if you mount the valve on the 1X9, on the column (just as it was on the 1450) everything else should fall into place.
The cylinder, bracket, rock shaft and related parts are the same between the two.
__________________
More IH Cub Cadet Parts RIGHT HERE
|