Quote:
Originally Posted by CADplans
I would reset the governor. This is a perfect description of a governor out of adjustment.
Or, next, check the timing, but, I really believe it is the governor setting.
JMHO  |
Thanks - I searched through the technical library and forums I could find the Kohler manual and governor adjustment. The procedure in the manual sounds a bit different than I heard and/or read here and elsewhere before. Other procedures have you holding the governor arm a certain way, etc. The manual just has you adjust for high speed with a tach - which I don't have.
As for timing I found a link for static timing but when I clicked on the static timing link in the technical resources section, it did not work. Anyone know of an alternate source for that info?
Thanks again!