Gas Tank Repair
I finally decide to fix the gas tank. I rinsed it THOROUGHLY with water. I found 2 pinholes that were leaking. One was near the seam, and the other was near the filter. I fluxed and soldered both areas, then just for fun I had some grey paint left over from another project. I put some electrical tape between the tank and its mount...couldn't hurt.
I am going to make a new front pulley for the engine from steel with a larger diameter to charge better at low speeds. No PTO. Has anyone done this? Advice for size? Can the generator spin too fast?
Also, Is this the stock clutch guard?
Thank you all for your help and input. This is fun!!!
|