Quote:
Originally Posted by Nightow1
they fit took a little time to get it just right, but they slid right in.
|
Well that's good. Then what I did from there was wire the front up to where it should be "about" then made my uprights to just above the quick connect and clamped them, this way you can move them around a little to get them strait.
Drilled the holes for the "ears' (mark them and take them off to be drilled together in a drill press, if you have one, much easier) and slid the rod through to make sure the fit would work in the quick connector of the tractor.
After I was convinced everything would work I welded the uprights to the sub-frame, then slid the rod through and welded. I know it wasn't made that way, they "ears" are separate to each side, but I figured if it's connected it will be that much more sturdy.