[FarmFresh]

I spent today adding power steering to my 1810 Diesel project. I used power steering parts from a JD318 and modified them to fit the cub. Space is very limited with the large Kubota engine so it took a ton of cutting and welding to make it all fit. I had to remove 3 inches out of the steering column and that was a fun task. Then it took a while to get the spindle and cylinder geometry figured out and to get the spindle reinforced, but now just a few lines and it will be moving and steering. I did not take any pics during but here is a few when it was done. I raised the column a bit over stock, but with the air ride seat it is super comfortable (especially since i'm 6'4" tall). Hopefully I can get the hydraulic lines and the foot hydro controls built this week.