You also might want to check with member jcrews I think he did the same thing, Put a #1 Tiller On his 1450.
Check this out Trent it might help. It is a post from a blog I found.
I been receiving calls for rear tiller's an drive units and drive belts. that these belts are hard to find an if you do they are very expensive. We have a supplier for the belts and soon as I get them shipped I will post them on my product page. WILL NOT BE $100.00 DOLLORS FOR THE 7/16 X 145" PTO DRIVE BELT. This belt is for wide frame tractors only. Serial # 530,000 to 665,000 Quiet Line. The other belt for the wide frame Serial #400,001 to 529,999 13/32 x 143.8 so check the tractors serial # located down on left side of tractor down by your break pedal or clutch.
The narrow frame Serial # 400,000 and Below. PTO DRIVE BELT 13/32 X 143.8" is the belt that will cost allot not sure why either.
The belt that goes from gear box to the tiller pulley 13/32 x 53" is for all models. Models #1 1a 2 2b.
The Gear Box Drive is what are hard to come buy so if any one has one or tiller an drive let me know ASAP.
The belt for the 82 series 21/32 x 154 5/16 " and beware this is a 5/8 belt not the same as Quiet Line 7/16 belt. If you buy the wrong belt and try to use it, will bottom out on v pulleys and just burn up and waste your money.
Well there I have filled you in as to what size's of belt's it takes and hope you will allow me the chance to sell you a belt as you now have the size it takes. Thank You Captain Cub
|