[johncub7172]

Well, you will need [4] 3/8ths. x 7/8ths. cap screws to fasten the creeper drive attachment to the reduction cover plate, a gasket; I prefer to use a thin coat of a gasket sealant with gasket and recommended Hy-Tran fluid, or SAE 30 oil for the creeper drive attachment. The installation manual will help.

There are 3 different creeper drive attachments that I'm aware of: two of the three are the same, but take note of the shift handle as to what tractor model you would like to install on. The other creeper is for a 82 Series IH Cub Cadet and has a aluminum body of a different shape. Yes, the creeper drive attachment for the Original is for the Original only.

Make sure the creeper attachment has, and comes with a good drive coupler. I believe a creeper attachment from a wide frame can be made or serviced to fit a narrow frame, again , it's a matter of the handle only.