50 hp might be a little much, but it's what I've got.
It's 1.6 liter, 17 inches long.
I've given some thought to vibration.
Once I settle on a design I will decide if I'm going to use dampening mounts.
In theory if I use two three speed trans for an articulator, with a chain drive transfer case, that's about 20 hp an axle, not really but close enough. Plus I intend to add hyd. to tractor so that's another 10 hp.
I know the math doesn't add up but like I said it's what I've got and if I can find a clutch setup that works for my application, that is an articulating tractor I should be ok. I think.
If I can't find a suitable clutch for articulation than I will have to go 2wd. I don't plan I using it for competition. Probably going to use some kind of double disk set up. just not sure yet.
|