Quote:
Originally Posted by ironman
Dagenham...this past summer I did a set (my first time). They were brand new AG tires on rims that I sandblasted and painted with KBS Rustseal so I went tubeless. I mounted the tires and inflated them to seal the beads, then broke the bead on the valve stem side only. Laid it down on the floor valve stem side up and the sidewall pushed down below the rim edge enough to pour in the liquid. Poured in my decided upon amount of liquid and used a ratchet strap around the center of tire to expand the bead back to the rim, pumped in some air to seal it and that was it. Piece of cake, nothing needed but a ratchet strap. The hardest part was breaking the bead after it had been seated.
|
This is how I did mine...