Sam
I the bumper I made bolts to the frame and I put spacers behind the bolts to allow attachments to go between the frame and bumper mounts.
image.jpg
This is the mount I made for the blade. It slides up between the frame and the bumper mount. The upper 5/8 rod goes in the CC front mount and the very front 1/2 bolts (one on each side) keep it in place.
I moved the up/down cylinder to the center. It was to the left. I had to narrow the "A" frame about 1-1/8 on each side to fit w/o the tire rubbing when turn sharp.
I hope it all works, just waiting on sno to see????