Cast Deck Mower Rebuild
While we're on the subject, when I rebuilt the 38" mower on my 71, I did all the mower disassembly and reassembly, except removing the old races and inserting the new bearings, races, and bushings.
Any ideas on how to remove the old bearing races without marring the housings? I tried tapping around the edges with a screwdriver and hammer, but they aren't moving and I don't want to score the casting walls. The problem is that there are two races about 1/2" from each end of the housing and I don't think I could drive both of them out of one side of the casting with a piece of pipe.
|