Quote:
Originally Posted by Mr Bob
Have this old 149 that I bought last winter. Used it very little since purchase. Just seen that it had worn the S/G belt badly. S/G pulley and Front Engine pulley seem to be out of alignment. Is it possible to move the front engine pulley away from the engine about 1/8 inch? Would this affect the pto going back on properly? Also had to put a bolt through the inside lift arm to raise and lower the mower deck. I will try to attach photos. Does the lift setup look normal? Thanks in advance for all your help.
Bob
|
Looking at your pics, I think you have a spacer behind the pully on the S/G. Try taking the S/G pully off, remove the spacer, then replace the S/G pully. You can check to see if the belt will line up correctly without the spacer before tightening the nut for the pully. If that's not a spacer, then disregard my advice. I don't use the spacer on my S/G.