Pully on 149
Thanks for all the reply's and advise. Had the pulley off the s/g but don't remember seeing a spacer. Turning the s/g pulley around may work. I have the pto and bearing off the crank shaft but the bearing was sitting at the end of the shaft when I took it off. I have been soaking the shaft around the pulley with pb blaster but so far It will not budge. Drilling holes and using a puller is a great idea but how did you get the nuts on the bolts in behind the pulley. Can any one chip in about the lift arm? Without the bolt that I put in the top hole, it will nor raise the mower deck. Also I have mounted a 54" snow blade and I read some where on the forum not to lock it, what ever that means. Thanks for all the help.
Bob
|