Quote:
Originally Posted by jimbob200521
Hmm...well, that leaves a bit of a head scratcher then. As it sits right now, when I go from idle to say 3/4 throttle in one quick move, it revs and works like it should. However, when I go from idle to 3/4 throttle slowly, it seems hesitate or studder for a second while it revs up. Any thoughts on this one? 
And I ordered the proper governor linkage yesterday and a couple other little things, should be in by the end of the week.  |
That has nothing to do with governor position. Probably should pull the carb and clean it/ tune the motor up.
Governor sensitivity example:
1.) You are blowing snow. You plow into a pile, the motor pulls down, but doesn't try to pick back up. Pulls down more, then starts trying to pick back up. Or, same scenario only it pulls down immediately and too far, then tries to come back. The governor isn't set to be sensitive enough.
2.) You are using your tractor out in the yard. Half throttle pulling a trailer. Every time you move the hydro handle the engine jumps up in RPM and really comes to life, then immediately calms back down after the initial movement of the tractor. Governor is set too sensitive.