Oh...that might explain how redwaycc uses the arbor press...
Anyway, my method would be the same. Hammer and brass rod until it's flush, then use a roll pin punch. Make sure you use PB blaster liberally. Try to see which end of the pin looks like it's been beat on, and then drive it out from the other end so you don't have to try to drive the mushroomed end all the way through the hole.
I can't comment on what it's worth, as there are too many variable. Just about everything except CC used the wide base oil pan. They are not interchangeable either, if I remember correctly. Can you post a pic of what you have? That'd help...
|