Quote:
Originally Posted by Redblower
The issue I'm having is on the other end, but by that parts shot you have I can't tell what #'s 6 & 9 are?
Thanks, Vic
|
#6 is a sleeve spacer, and #9 are "C" clips. That schematic shows our pulleys being held on with the "C" clips.
That is an error, our pulleys are held on with the square head bolt.
That sleeve and "C" clips are what hold the driveshaft yoke, onto the gearbox output shaft.
That's why even when the shear pin breaks, the shaft stays on the gearbox, just free spinning.