Wish I could see the end where the rod comes out of the cylinder, they look like the cylinders on my Johnson FEL. I just replaced the seals on the bucket cylinders for the same reason about 8 months ago. Remove the push rod dust seal and there's a internal C ring just below it. Remove the C ring and pull the push rod out of the cylinder, the top support bushing will come out with the push rod so it will be easy to check for wear or damage. I took my push rod assembly (with dust seal) to my local Farm Supply parts counter and they matched up the O rings, Teflon O ring spacers and dust seal for my cylinder. I got enough part's to do all four cylinder's for about $25.00 since the lift cylinders were the same dia. It was allot easier than I thought it would be.....Good Luck
|