well so far the govoner is working but not a lot of throttle. I took it to the chainsaw shop today and back. When i started out in 3rd. gear, the gov. seemed to pick up torq. I'am guessing that the throttle bracket is not set correctly, the speed disc rides on the back side of the brass nut,[around the stem-part of the brass nut.] And i believe the throttlebrac. is forked to the gov.shaft. I have the t.controll cable in the correct hole in the speed dics. And about the pin in the S.D that stops at the throttle bracket. Its not over reving, but backing off the gov. shaft and dropping down. Could be that the gov.arm needs re.adjmnt? But to tighten up the brass nut is a challenge, but too tight and the shaft dont turn. After it warmed up good by going to the shop, is when i could see the slack in the gov. setting. i still can get a pict. up of the old 7hp. to show where it is set at.
|