[dakota1205]

Have an 2072 with a Kohler repower CH730-0097 engine in it. looks to be a 2004 year model. Had to replace the rear seal in it, so while out (and had to remove ignition coils anyway) I thought I would ohm the coils (reason being, after mowing for a while and shut it off, it backfires and wants to stay running, then finally shuts off) one coil reads 8.97k ohms to ground and the other reads nothing. I believe the one reading nothing, might be bad. Is there a correct way to ohm them or do you have to have connected back up and check it at the spark plug with a tester.

Thanks for any input

Randy