Quote:
Originally Posted by J-Mech
Bill, that dimension is correct for the implement.
On the tractor it should be narrower on the lower spread, and shorter from lower pins to top. (Maybe that's what you meant.)
|
Ya, 20" is the implement end of the arms, I'm like 10 1/4 width on the tractor side. So it should be shorter than 12" from the lower pins to the top link? I went 11ish because I ran out of room, I was shooting for 12". I guess if the tractor side is shorter than the implement side, it will tilt the implement up as you raise it effectively giving you more lift. Hadn't thought if that, guess I'll be drilling a lower top link hole in the bracket! Is there a standard? 8"-10"?
Thanks
Sorry to the OP, I apologize for hijacking your thread.
Bill