[ccr147]

Hey guys I've got a question about the spindles on my 48" deck on my 147. I believe the tractor is a late 70 or early 71. I took the blades off to sharpen them and after I put them back on I tested the deck out and I noticed the cut is a little off and it was making a noise. So I looked and the outer blades are spinning when I hold the spindles still. I did tighten them down of cours and the nuts were still tight. I got looking at the parts diagram and noticed the later decks show a friction disc between the spindle and the blade. I've never had those. Can I replace those with a washer for the time being? Is there an obvious way to determine if they should be on there?

Thanks.

Curt