Finally got to look at it. I noticed the throw out wasn't moving out when I engaged the clutch and neither was the friction plate. I put some oil on them and have them and they are moving much better. Once I put it in gear it will allow me to switch gears with no problem as long as the clutch is pressed in. Now if I let off of the clutch at idle and not in gear the gears will grind when I put it back into gear but it is fine after it is in gear. I do notice with the teasing spring which appears to be the small spring behind the throw out is missing except for one wrap where it appears on the parts list it should be 4-5 wraps around the drive shaft Do you think this could be the prob. To me this spring seems like it should push the throw out toward the clutch putting mor pressure on the clutch. Any thoughts would be appreciated!
|