[OldCubby]

ok, so I got the new idle spring. While I was at it. I ordered a new brass governor shaft nut. I got the old one off and put the new one on. Now, my governor is all out of wack. Here's the issue....when I took it apart....i'm not sure I put the tab back on the governor correctly. If I take the nut back off and use a flash light I can see that I can orient the tab horizontally or vertically. Now, I don't remember how it was when I reassembled the engine...but I did could see up through the oil pan to ensure I assembled it correctly. I can't do that this time. So, if I were to look inside the hole, how should I see that tab? Horizontal or vertical?