Quote:
Originally Posted by Alvy
Todd, I mixed up some epoxy like stuff, JB weld if you will, put it in the egg shape and then sand it down to make it round again, then put bushings in. I tried to get a machinist to make them accept bigger bushings but he couldn't chuck them in his lathe. Mine have been leak free so far. If not, Your buddy in new joisey has some for sale I think.
|
Yep, talked with that buddy today, and it was mentioned you were going to try and do something with your tubes. That got me to thinking that just maybe there was hope for these axle tubes yet.
I'm going to go into town tomorrow and see if there is any hope for the axle tubes, and while I'm there going to have him look at the spindles and see what if anything can be done to correct that end.
