Quote:
Originally Posted by TIMCRUTCHER
There are two set screws in each hole. Have you taken all of them out?
|
Quote:
Originally Posted by tonka.scout800a
Mine had 3 short and 3 long, 1/8 allen head set screws holding it on. Are all yours removed?
|
If the arm is still on, pull it back and rotate the pto until the U shaped cutouts line up. If it's off or disconnected, light taps with a hammer on the button will allow you to rotate it until they line up.
Make sure the holes and the hex are as clean as you can get them. Use a high quality 1/8" hex wrench to loosen the set screws. There should be TWO in each hole for a total of six.
After they are all removed, then you should be able to get it off.