Quote:
Originally Posted by jimbob200521
Looks good Sam 
So the oil return holes you drill, they have not been done in those pics, correct? I'm curious to see more pics of that job. |
Ryan
I replaced the pic with one that has an arrow pointing to the return hole. Very easy to do, just drill a 3/8" hole at the bottom next to the tube mounting area. Only takes a couple minutes to do both sides of the case with a cordless drill. Problem is the rear has to be out of the tractor and you need to remove the axle tubes. Biggest PITA on this job is scraping the old gaskets off the tubes and the trans housing.