Update, the timing issue is resolved. The mark the original owner put on the flywheel is TDC. I had the timing set on .016. It is now reset to .02 but still wouldn't go above 3600 RPM even with the throttle wide open.
I put a new carburetor on it #26, and now it has no problem going above 4000RPM, so my carburetor must have been worn.
The governor is still set at 3600. Any suggestions on governor settings to get it to 4000 with no load?
I read on Brian Miller's site that you put the spring on the bottom hole of the L shaped bracket and the upper most hole of the throttle cable bracket to increase RPM. Is this correct or is there a better setting for pulling?
Thanks
|