Thread: New to Pulling
View Single Post
  #82  
Old 11-21-2014, 02:11 AM
bschmittling bschmittling is offline
Senior Member
 
Join Date: Mar 2014
Location: Mississippi
Posts: 139
Default Recap

I am running a Cub 124 that may have pulled before. I don't know what has been done to the engine but it is strong. The clutch is good and it has a red spring. What I have done so far:

Wheelie bars
Adjustable hitch
New #26 carburetor
Kill switch
Front weight bracket
100 lbs of suitcase weights
New Carlisle super lug tires (that is another story)
Vogel 12x10 aluminum rims
10" front tires
Added a switch to disable the generator
Bosch coil
Point saver ignition

Extra parts I bought before I figured out what I was doing and have not installed:
Fine splined rear axle and differential
Aluminum 6 pin 3 puck clutch and heavy duty drive shaft
Electric fuel pump

The competition is mostly running K301s with Bosch coils and Tru Power tires.

My question is, what do I need to do to win next season? Go ahead and install the fine splined differential? Add an over drive gear? Any suggestions are appreciated. I will rebuild the engine after next season.
Reply With Quote