Quote:
Originally Posted by gdheck
I use migs for sheetmetal a lot, but I haven't had good luck in this type of situation. I have to remove a lot of bolts from 1/4" - 1/2" that are broken off well below the surface of a cast iron part and the wire can touch a thread above the bolt where a stick won't arc as easily. In this case a mig will probably work ok.
|
I get broken bolts out all the time with a MIG. Never have an issue, or bad luck.
Guess I'm just arguing here for no real reason. Point I'm trying to make is, if you know how to use a MIG, you will seldom pick up an arc welder. Both welders have their place. Just like all tools. I'll bow out. I really wasn't trying to debate.
