44c Deck Help
Guys,
I've had the 682 & 44c deck since new so it has burned a few tanks of gas & I've done my share of repairs over the last 28 years.
My problem is trying to get the blade cutting height above 2.25" to something more reasonable like 3.0 - 3.25".
Is there a site that has found a good way to achieve this? Looked through some of the past threads but no luck as some of the links have been disabled.
May try to fabricate an adjustable link with an offset for the left side but the overall deck design does not seem to allow higher grass cutting heights. Have tried using a duplicate adjustable hanger like the one on the right side for a few years with reasonable results but this creates some other alignment problems.
TIA
|