The learning curve is growin' fast.
With our "new" Cubbie, got the deck 'n hanger off. Was a pain removing the cotter pins from the two lift arms.
Duh! After removal, playing with the lift height adjuster on back of the Cub, noted had we turned the height adjust left, could have lowered the rockshaft arms below the frame. Live 'n learn!
Lowered as much as the threaded adj would go the pins are visible but only down as far as the frame (just slightly lower than the lower pan).
Is this the max low? Or, might the threaded adjustment screw we needing cleanin' or something?
The lower pan cover (or whatever it's called) is awful rust junqué. Plan to replace with new. Any source for the low pan cover piece?
