I posted this on another thread before I realized I needed to begin a new thread{?}
Under the topic "Spirol pin question ..982 Rockshaft assembly" I had posted about a collision with a hidden tree stump while plowing, and having done a faceplant into the windshield, and the washer and bridge pin popping off of the lift tube resulting in the tube dropping to the ground at the lift arm end...after replacing the washer and bridge pin , thus re attaching the lift tube, I had only about 1/2-1" of lift..
anyway .my springs failed to tilt and the blade/ assembly..took the full force of the hit...Could the force of the 2 collisions have cracked or damaged the hydro ? I have a huge puddle of fluid under the rear of the 982, and have only a small idea of where or how to start tracking this down., as I am hoping this will solve the lift problem.
It has been way too cold to be out there working the past week or so.(.I cannot stand to wear gloves when working with my hands).
You all know any help or advice is much appreciated
