Evidently I had the clutch too tight, I pulled it back off and backed off the tension at the advice of a member here and it disengages fine now. I know I won't use that gauge again, just adjust it by hand, I set it 3 times using the gauge, never worked but worked fine adjusted by feel. I added a couple washers to shim the rockshaft from sliding sideways and redid the mule drive using a couple of Primeline 705482 pulleys. These are listed as heavy duty, we will see. I welded the mule drive pulley arms together and ditched the spring. This enabled the belt to tighten more.
|