Quote:
Originally Posted by swacor
I still haven't got it right. I've tried everything I can think of. Its starts up and idles good then it all of a sudden stumbles. If I pole the choke out a pinch while it stumbles it straightens out but if I leave it out its almost like it gets to rich then I have to push the choke back in. After that it seems to stumble again after a few seconds. It just seems erratic and not right. Is it possible to get that transfer tube backwards (the tube that goes from upper to lower housing) The service manual shows its position different than the parts diagrams show.
|
Hi, i think you might have a bad head gasket. Mine ran just like yours and the plugs looked the same. It was on the right side, setting on the tractor. After seeing the bad one i changed them both. Replaned the heads flat. Mike