Quote:
Originally Posted by cub123
Sounds like you have I good idea what you want. I just took a few measurements on my 1772 with the the rims like Sam had made, it's right at 42". I don't think i would go less, the front is about 42 anyways and you would have to keep an implement or spring on the lift arms to keep them from hitting the tires. Welding the centers isn't too bad, run a straight edge across the rim and measure to the four corners of the center, once you get them all the same tack them and double check the measurements. Oh, be sure the three point rockshaft isn't hitting the fuel tank in the full down position, I had some small issues with that.
|
Thanks for the measurement on the rear. That sounds like it's right where I want to be. I will also have to watch out for that issue you had with tank clearance.
I also have a new dash I have to get installed. I bought it last winter and just never got around to getting it on. Should be an easy job once I get the steering wheel off.
The main reason I went with new wheels is so I can keep my turfs and chains mounted for winter use. I already have those loaded and I really didn't want to break them down.