Thanks guys. I will have to ask a couple of buddies that weld to see if they can hook me up with a fix. It might just be easier to pick up a used one for 60 bucks if it is going to cost 50 to fix this one.
By the way....at one point I ran across a post that someone put a spacer on the mower lift arm (the one that the cylinder pushes on) that would allow the lift to raise a little higher. I figure if I am going to be working in there, i might as well put that modification in at the same time. I have searched the last couple of days and cannot find that post. Can anyone steer me in the right direction?
|