Those are the snubbers that go under the front ends of the cradle between it and the lower frame flange on a QL, one on each side, and get adjusted w/slotted flat washers so when the PTO load has a tendency pull the cradle down it will go only so far.
You can see the bolt that holds the eft one, I can see it in your 4th picture, just ahead of the ISO mount
Spacing spec's are .06" to .12" w/no load.
Add or remove shims as necessary to achieve this clearance.
Amazing what all you can find in the FSM's and FSM's
Best part is, it's all FREE, can't beat that!
|