Quote:
Originally Posted by Mr Bob
Need some advise from you members in the know. Bought 2 new mule drive adjusters from a good member and a AX144 belt from Napa. Put them on and when I checked every thing out, it seemed there was a small amount of jerking noise coming from gear box. Holding one pulley and turning the other pulley, there is a little play. Took the cover off the gear box and it seems most of the play is between the gear and the pin on each shaft. Not a lot of play but it concerns me. Does it need to have the pins replaced? Will the tiller being hooked up make a difference? All advice will be appreciated. Thanks and have a great day.
Bob
|
I make replacement gear box shafts. If yours doesn't exactly match what I have listed, I can copy yours to add to the list ( and you get a discount )
My parts for sale thread
http://www.onlycubcadets.net/forum/s...ad.php?t=20875
the post with the gear box shafts
http://www.onlycubcadets.net/forum/s...26&postcount=2
Your bearings should probably be replaced too.