Here it is from another angle. I turned the shaft around and used the rag joint up front and had the shaft grooved for a key, that way the shaft can slide up to be removed. An Allen head screw holds it to the shaft, and the rear yoke to the hydro has a bolt turned down like I had on it before. I really like that over beating coil pins in/out-but I hope this setup lasts so I don't have to do this again. I found this info on Dave Kamps cub cadet site and basically followed it with some differences.
I've been running my original wallered out shaft and a 1/4" bolt for months, gotta till, garden season you know. Finally everything is pretty much done due to the heat.
The fan is farther away but no disc is blocking it now.
|