I think that the housing is fubar on 127
I like the grinder/drill press combo Oak.
Cleaned the housing out w/solvent like the service manual says.
I believe that the broken away internal flange is part of the casting and if you look at the other photos you can see bearing balls imbedded in the walls. I've never had one apart but this isn't following the original design I'm guessing. Also if you can make out the bottom(inside of the adjusting screw), it is terribly gauled up. Most likely the reason I can't get the adjusting screw to budge. Opinions welcome.
If anyone has a housing for sale let me know.
Thanks,
TT
|