[_DX3_]

I was able to find the 5/8 cold rolled steel rod for upper lifting cast for my 3 point attachment lift. Had them cut me a 12 in. piece and brought it home and drilled a hole on each end for the clevis pins. Lubed it up with anti-seize and still had to use a hammer and drift to get it pushed all the way thru, but it went pretty easy with just a small amount of persuasion. My 2 1/2" wide flat stock will be available tomorrow for creating the lower mount to use the craftsman sleeve hitch adapter I have available. This will give me something to do for the next few days while it is near 100 out. Ughhh