Hood is on. I'm going to modify the exhaust so that it exits straight down rather than cut a hole through the grill. The factory design did a nice job of melting the hood around the exhaust pipe. Plus the pipe was hitting the hood and grill every time you went to open or close it. Found a j-bend 1-3/8" OD pipe on Jegs that looks like it will fit nice with a little cutting and welding. I may add some type of insulation to the top of the muffler box. Have to see if it's needed after I get the pipe on it. Also ordered the proper decals for the hood. Time to service it and get it cleaned up and ready to sell.
__________________
2264 with 54 GT deck
1641 AKA Black Jack with a 402-E Haban Sickle bar mower
JD317 dump truck
BX2670 with FEL
|