Quote:
Originally Posted by Willy1215
I bought a used PTO clutch at an auction a while back for my 2082. It works but needed the bearing replaced. I have a new bearing but now realize the sleeve (if that's what it is called) that goes inside the bearing and over the crank shaft was missing. Does anyone know where or if i can get another one? or maybe have some measurements so i could have my buddy turn a new one on his lathe? Any thoughts are appreciated.
thanks
|
Can you use your old one, or did you not have a clutch to take it out of?
Here is what I'm thinking you need but Prolly the dimensions are different, so it will be of little help other than a reference.
http://www.ihcubcadet.com/forum/mess...tml?1331850923