Hello guys and gals. I have a 680 Hydro (based on the 82 series I believe). It came with a QA36A snow thrower. I am in the process of trying to get it installed and the belt is giving me trouble. I understand that it should take either a 28" or 30" belt, but I can't even get a 1/2" by 32" belt to fit. The physical connection of the thrower to the tractor was easy. I believe it was just as simple as guiding the blower into the quick detach receiver and bolting the right arm/strap on (I do have a QA36-42 owner's manual). I had to put the lift linkage on too, but it was a breeze. The belt is the issue. I have the tensioner that is on the side of the blower (left hand from cockpit view). I have it maxed out. The 4 bolts that move on the mounting plate are free and bottomed out on the adjustment slot. I can't figure out what I am missing. I know that ideally I should be using a 36B thrower, but the "A" came with the tractor along with a 30" belt. Any thoughts on what I am missing? I am thinking of ordering a couple belts: 33", 34" and possible 35" from McMaster, but I want to get your opinion. Thanks in advance for the help. Here are some pictures of my setup.
Belt too short:
All the connections in place (I hope):
Adjustment cam (boys, I need to clean under there
:
Model Info (blower and tractor):
Thanks again.