An update on the 100. After a carb kit and a coil, we got it running again. Everything seems to be functioning well, including the loader. The rear end had a seal leak and the engine was coughing up oil through the blow by. Decided to take care of the transaxle first. I decided that if I was going to have to take it apart to replace one seal, I would take it all apart and replace all the gaskets and go over the bearings. Overall, it was pretty clean. A couple races needed replaced, and I ended up getting a different set of axle carriers that used bearings instead of brass bushings as I couldn't find the right bushings to fit properly. Finally getting the transaxle put back together. Just waiting on new brake linings and I should be ready to get it all back together.
|