Quote:
Originally Posted by gkingbing
Is there any chance that you could make power angle brackets to support the hydraulic cylinder? The ones commercially available have 5/8" rods on them and the closest cylinder I can find will require 3/4" rods to go into the cylinder pin holes.
|
Just a FYI you can pick up bushings at TSC that reduce 3/4" to 5/8"
http://www.tractorsupply.com/tsc/pro...g?cm_vc=-10005
__________________
2264 with 54 GT deck
1641 AKA Black Jack with a 402-E Haban Sickle bar mower
JD317 dump truck
BX2670 with FEL
|