I'm going to be taking the block and crank over to the machine shop this week. Should I remove the governor cross shaft or is it fine to leave it in the block? Also, I've read that its a good idea to replace the governor cross shaft when rebuilding the block should I go that route or is it ok to reuse in your experience? Lastly I am going to order parts for my pto and begin rebuilding it. I've got it apart and it seems I'm going to need a standard rebuild kit plus a thrust button. The screws/nuts that go through are pretty rusty and I want to replace them, thing is I've never seen them before. Can similar screws/bolts be found at a hardware store, if so does anyone know the specs? Once again thanks for all the help guys!
|