Quote:
Originally Posted by darkminion_17
You would not be able to put those parts in from the other side,#9 is held in by a roll pin,how do you install it with the housing on?
It goes together like this.
1 press bearing on shaft,install small snappy ring.
2 install bearing and shaft into housing.
3 install snappy ring in housing.
4 install thrust washer.
5 install planetary gears.
6 install gear # 9 with shoulder facing planetary gears.
7 install roll pin in #9 be sure is flush to the gear .
8 install sliding gear # 10
9 install O ring on bearing housing.
10 install whole assembly into creepy housing.
11 install snappy ring.
|
Not saying your method is wrong, but if you put #7, #9, #11 and #12 together first (along with the pin that holds #9) then you can slide the whole assembly in and put snap ring #8 on then put the seal in.
For instances like this, where it is difficult to get the cage properly seated into the housing, installing the thrust washer and cage first may make the process easier.