Okay, took the clutch apart today. After reassembly after the "face-lift", the clutch/brake peddle would stick. I did not take the clutch apart at the time because it seemed to work fine, but now it does not. Have to pull it up by hand to get it to engage.
So figured I needed to find out what the trouble was/is... For one the drive shaft is grooved, the IH-376259-R1 Bushing, Clutch Release Collar is worn, as well as the IH-376282-R2 Bushing, Clutch Shaft. And they are both NLA.
I did order IH-376265-R1 BUSHING, 732-3017 SPRING-COMPRESSION, TC-780007 Washer, Clutch Release Thrust Brg, IH-368372-R91 Bearing, Needle Thrust from my dealer.
Clutch drive seems fine.
So where can I get the two NLA parts, or is someone making them? I'm going to contact Jeff in PA to check on a drive-shaft.
photo uploading websites
adult image
screen cap