Quote:
Originally Posted by ironman
For extraction, I was wondering if anyone has tried using these things. Kinda similar to an easy out, but you can go both ways, loosen and tighten. Looks doubtful though that the 1/4 inch one could go down the hole far enough to reach the lower allen screw.
http://www.lislecorp.com/divisions/p...s/?product=376 |
You can use a #15 torx bit, they are a little snug and will need to be tapped in with a hammer. I've used them before with mixed results, they work better if the side of the set screw isn't cracked.